I need 4l60e parts! - Third Generation F-Body Message Boards

BIG_MODS · 04-23-2008, 05:55 PM

I'm hoping someone has a 4L60e torn apart and sitting in a box in the corner of their garage somewhere.... Or maybe you know someone that does?

I need a couple parts to add a VSS to a Jerico Trans:

40 tooth tone ring - It's pressed onto the outpshaft of the trans. Probably pretty tough to get off, so if you want to send me the whole shaft that's cool.

Vehicle Speed Sensor (VSS) - It's located in the passenger side of the tail housing.

Harness connector for VSS - self explanatory

These parts can be found in 1993 and newer 2wd trucks and 1994 and newer rear drive cars.

This is a long shot but I'm also looking for a DRAC (digital ratio adapter controller) from a 89-94 S10, Astro Vans, and 90-95 full-size trucks. The VSS is wired into this and it conditions and applies a ratio to the signal that goes to the speedo and ECM.

Let me know if you can help! Thanks, Stan

midwest · 04-23-2008, 10:21 PM

Quote:

Originally Posted by BIG_MODS

I'm hoping someone has a 4L60e torn apart and sitting in a box in the corner of their garage somewhere.... Or maybe you know someone that does?

I need a couple parts to add a VSS to a Jerico Trans:

40 tooth tone ring - It's pressed onto the outpshaft of the trans. Probably pretty tough to get off, so if you want to send me the whole shaft that's cool.

Vehicle Speed Sensor (VSS) - It's located in the passenger side of the tail housing.

Harness connector for VSS - self explanatory

These parts can be found in 1993 and newer 2wd trucks and 1994 and newer rear drive cars.

This is a long shot but I'm also looking for a DRAC (digital ratio adapter controller) from a 89-94 S10, Astro Vans, and 90-95 full-size trucks. The VSS is wired into this and it conditions and applies a ratio to the signal that goes to the speedo and ECM.

Let me know if you can help! Thanks, Stan

The tone ring is not pressed on. It has a slight interference fit, but it comes off with a brass drift and light hammer strikes.

The vss they still make, carquest has them.

The drac also called a speedometer buffer in some publications, can be gotten at a gm dealer.

BIG_MODS · 04-24-2008, 01:23 AM

You in a bad mood or something?

Quote:

Originally Posted by midwest

The tone ring is not pressed on. It has a slight interference fit, but it comes off with a brass drift and light hammer strikes.

Interference fit usually means that it's pressed on. Good to know that it comes off easy though.

Quote:

Originally Posted by midwest

The vss they still make, carquest has them.

Yeah, but it's $105 depending on where you get it from. And there is probably a few hundred thousand out there in a wrecking yards or in someones garage that aren't being used.

Quote:

Originally Posted by midwest

The drac also called a speedometer buffer in some publications, can be gotten at a gm dealer.

Thanks for the info. I didn't know that already.