ExhaustPost your questions and suggestions about stock or aftermarket exhaust setups. Third Gen exhaust sound files and videos!
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
I read a bit on these in this forum . So I thought it was only fair to contribute some pictures back . I tryed to take some sugnificant shots .... with a measuring tape in front of them ...to give an idea of what they were .
...where the y pipe meats the cat
same as above ...but with a measureing tape ...I thought they were 3"inside diameter
a picture looking inside the primaries ....but where the AIR tubes were ...was some nasty metal .... that needed to come off . I thought they would be a little better in this regard .
where the y pipe splits off... looks to be less than 2.5 inside diameter
another showing the same dimensions
The y pipe itself
The Passenger header .....
Thanx agian thirdgen ...for the info I have read on these
__________________ PROJECT UGLY DUCKLING
1989 10:1 353 L98Edlebrock base and runners ( really ported)ZZ4cam ,1 3/4 SLP shorties 083 heads ...cleaned up andstuded w/1.52 rr , LT4 valve springs and retainers and a 3 angle valve job
suspension mods (Hotchkis LCA's PH bar, KYB shocks and struts)
T-5 3.73
T-62 turbo to be installed next ...Exhaust clip ...gota let it load.... http://media.putfile.com/My-exhaust-clip
I am interested in your setup. I am hoping you are still running a tpi setup. I noted at your are in Ontario as well. I have a similar setup to yours. However mine is not running so well, I hope it is just programming. I have 1-3/4 slp headers, World Sportsman II heads a ZZ9 cam and a roller set-up. I am currently running a stock ARAP program, but the car is not revving well at all. I runs like a sick dog. It sounds very very strong but not as crazy as it should. I am hoping it is programming.
My first question is about your programming. Are you running a stock program with a MAF?? Also let me know what you encounter with the heat generated from the headers. I melted three spark plug boots and wires. After replacing them I insulated them with MSD sleeves and this weekend I hope to put header tape on the headers. It is a shame to cover the headers, but I can't afford to replace parts due to the heat. Let me know how things are going and where in Ontario you are from...
