This is an aftermarket fiberglass High Rise for the 91 and 92 Camaro. I don't want to mess around with trying to install it so I think I might get a Hawk's 5" instead. The spoiler has fresh paint.
Make offer + shipping
__________________ Headmen Headers, Magnaflow Cat/3 inch cat back flowmaster muffler. Edelbrock open air element with K&N Filter and K&N top, 350 swap, 342 posi rear end, iroc-z suspension, B&M Megashifter, TDS Wonderbar, Full Accell tune-up and Coil, 3" Harwood Cowl, Torq Thurst II's, Clear Side Markers, Hawk's 5" Spoiler.
Last edited by XxGeinNothingxX : 04-13-2007 at 11:41 PM.
How much are you asking?
----------
Sorry, I didn't read far enough down the post....
Ya, just send a PM. I know these usually go for 200. I will take less than that for sure though. Just make a reasonable offer and we can go from there. Too bad it has fresh paint though now, you might not have a dark red metallic car lol.
Soultron, haha, I am not saying it HAS to be ur cars color, just saying to bad if it isn't since it has fresh paint.
Iroc, I don't have the hardware for it. The owner before me had it but has no clue where it is, and I been searching for it, but can't seem to find what I am looking for, but I never knew exactly what to look for though. The only thing up for sale is the actual wing.....sorry
You can get the 'hardware' just about anywhere. I installed one at 10pm AT NIGHT IN MY DRIVEWAY on my '91 RS, lol, very simple job. Just need roughly 8 nuts/bolts or screws(i forgot now) and just some rubber/hard foam type insulation between the deck and the spoiler. Ya should be able to buy like a square piece of the insulation material and just cut it to fit.
Actually, I did infact buy a square sheet of foam to use as a gasket. I will also send that with the wing as well as some bolts that the body shop gave me to use. I am not sure if they are all the lengths they need to be, but I think all you need is 10 MM bolts. 8 like Cam-ro listed above.
