You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
I have a set of Weld Draglites that are off my Turbo Trans Am. The rears have MT ET DRAGs with about 6 passes. They are screwed on the inside and have tubes. Theres still alot of meat on them. The fronts are Skinnys with just some generic brand tire on them. I also have 1 extra skinny New in the box that I will include for free along with all the lugs, washers, and spacers. You can bolt these on and GO! Balanced as well.
Re: Weld DRAGLITES off my TurboTA Skinnies and Slicks
Willing to split? What is the rim size of the fronts? and what diameter tire?
Thanks
__________________ 1992 z28 drag car
Hooker long tube headers, '79 355 cid, 13:1 compression, world products sportsman II heads, Pro Form 750dp cfm carb, 1 gal fuel cell under hood
Stock 5 speed, beefed up 10-bolt, 4.11 gears, 26"x9" Hoosier QTP's
Best time: (w/ TPI, full interior, 3.73 rear) 13.24@ 103.24 w/ 1.84 60'
Stripped down and set up to race only: 11.72 @ 121 w/ 1.85 60' <---wtf??
Re: Weld DRAGLITES off my TurboTA Skinnies and Slicks
I'm not 100% on the sizes but if I recall the fronts are 15x3.5
rears are 15x10. The one picture shows the size of the slick. The front tire size is a 165/15. I had pictures but I can't find them, there were on my site at turbotransam.com but now I'm having no luck.
The rears will fit any fboby with the correct spacer.
1992 z28 drag car
