InteriorDiscussion about interior restoration, repairs, and modification.
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
steering column repair - housing support replacement
for all the experienced column repair folks out there...
The column in my 91 has been "loose" in that you could pull the steering wheel down (at about the 7 o'clock position) an inch and it would "spring" back up, so I tore it down.
It turns out that one of the pivot pins has "wallowed out" the hole in the housing support So, instead of being a tight fit, the pivot pin is just loose in there and allows the housing to sort of move around on the housing support.
Anyone know of a GM part number to get a new housing support?
For clarification, I'm referring to the chunk of cast aluminum that the inner half of the pivot pins push into, and is also the same piece that the 4 infamous bolts loosen up on.
if no part number, anyone know how common (or perhaps specific to a vats column) the piece might be in a boneyard? or any repair techniques - perhaps a competent machinist could drill the hole oversize and put some kind of brass or bronze bushing in there?
__________________ 1991 Z28
L98/G80/G92/J65
LT1 injectors, DIY PROM, t-56, AS&M siamese runners, accel intake, F1 GS-D3's
* 14.46 @ 93.36mph, 1.98 60' 7/5/02 (stock)
* 14.89 @ 96.76mph, 2.51 60' 7/7/04 (T56, AS&M SS runners, accel intake)
...guess I need to work on that rear suspension! 1971 RS
406/4spd...a work in progress..
in the 13's @ 107mph without a posi, it's a start.
Re: steering column repair - housing support replacement
mine does the same but some guy told me it has to do with the tilt wheel getting worn out, he also said that 3 bolts need to be tightened with the use of a "special" tool. I tried reading the repair manual but i am having a hard time finding those 3 bolts because the pics in the manual are not so clear. If anybody has done this in the past and has some pics, would you be so kind to post here your experience and the pics of course?? thanks in advance!
BTW the part number you posted is for the fourth-gen, as it specifies on http://www.gmpartsdepartment.com/par...&siteid=214533.
Last edited by lonesomecrow; 03-14-2008 at 11:30 AM.
Re: steering column repair - housing support replacement
the part number i posted is valid for the 90-92 airbag columsn as well.
I imagine you already find the pictures of the three bolts you need to tighten; if not, the job ahead of you isn't too bad. I can't recall any special tools you need though; just a general selection of tools, torx bits should do it; I don't think you even need to remove the pivot pins.
