jjohnston

I am trying to remove my back seats. I can't get them out. I can see a torx bolt in the side of the backs of the seats, but I've tried 3 different bits, and I can't find a way to get a torx bit to actuall fit in order to unscrew them...

This ad is not displayed to registered members. Register your free account today and become a member on ThirdGen!

bradley23150

There is a nut on both bottom sides of the rear upper seats, look where the lap belt would be, and feel under the bottom corner of the seat, and you should feel a nut, that is similar to the nut that holds the front seats to the floor. Keep the seat in the upright position as you do this.

Hope that helps.

__________________
Currently Building: 1987 Formula 350:
350 SBC bored to 357, aluminum pistons, PM rods, Full roller block. 700r4 With shift kit, Lakewood Lower control arms and adjustable panhard bar, Borg Warner 9bolt posi Rear, 4 wheel disc brakes, KYB GR2 Shocks/Struts, AG lowering springs, UMI Sub-frame connectors, Full Energy suspension bushings, 36/24 Swaybars, and much more

Brennan

and the bottom half has just one bolt in the front

__________________

Check the car domain:http://www.cardomain.com/ride/2974831
R.I.P. Andrew Melvin Bailey- May/3/1988- October/27/2008.

zapskate

umm there are upside down bolts and ur ratchet has to be upside down mine came out in 5 minutes!