InteriorDiscussion about interior restoration, repairs, and modification.
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
OK, I bought an accelorater pedal with the spring but can't figure out how to install it. I have the pin that goes through the hole that connects the plastic pedal to the pedal lever (?)
Can anyone explain to to install properly and do I have all that I need?
OK, I bought an accelorater pedal with the spring but can't figure out how to install it. I have the pin that goes through the hole that connects the plastic pedal to the pedal lever (?)
Can anyone explain to to install properly and do I have all that I need?
Thanks!
Call Toyota.
I'm just kidding. You know, in all the years I've been around cars, I've never had to R&R a late model GM pedal.
Mods so far: MSD Cap and rotor, MSD ignition coil, Accel 8.8mm ignition wires, Hooker Super Comp Shortie Headers, Flowmaster 3in catback, underdrive crank pulley, custom cold air intake, NOS wet 125 shot, air foil and a lead foot! no E/T's yet. ...TURBO COMING SOON...Other mods include keyless entry and remote start, and Sequential Turn Signals.
I've just had the same issue, you'd think this is bloody obvious but i've been faffing about trying all sorts of combinations but I can't figure out how the blinkin spring fits in.
Willing to admit i'm an idiot if someone can shed some light on the accelerator spring install mystery
The coiled part goes on the pin, to the right of the accelerator rod.The hook end goes on the accel rod, the straight end against the accelerator pedal.The pin goes in from the left side.I modified these to fit like the OEM pieces.
OK, I bought an accelorater pedal with the spring but can't figure out how to install it. I have the pin that goes through the hole that connects the plastic pedal to the pedal lever (?)
Can anyone explain to to install properly and do I have all that I need?
Thanks!
Where the bloody hell did you buy your accel pedal from?? im having the hardest time finding one! all ive found were the pedal pads or the accel rod...
