1986power

I have aftermarket oil, volts and water temp gauges i want to install, but would really prefer not drilling a hole through my firewall to send the wires and hoses through. is there an easier spot to get to that i can run them through into the engine bay from the cab?

91 camaro racer

iTrader: (2)

behind the brake pedal there is a hole with a plug or grommet in it. it comes out below the brake booster on the other side.

majobis

iTrader: (3)

and since you seem like you want a neat look, I recommend gauge pods for your gauges. You can get them at Summit racing. I ended up replacing my stock ones and sold the pod, but look here to see what it looks like: https://www.thirdgen.org/forums/inte...port-comp.html

1986power

i looked and the only opening is jam packed with wires already. any other suggestions?

91 camaro racer

iTrader: (2)

it was this hole?? pics stolen from google.

[IMG]firewall3 by jonnyc127, on Flickr[/IMG]

[IMG]firewall2 by jonnyc127, on Flickr[/IMG]

[IMG]firewall1 by jonnyc127, on Flickr[/IMG]

91 camaro racer

iTrader: (2)

it might have a plug in it as shown in the first pic.

1986power

yeah it is that hole. i couldent fit a wire through let alone the sender units and bulky oil line with all the wires in it already. i can take a picture of it.

91 camaro racer

iTrader: (2)

oh ok. mine was completely empty...strange. you could always drill a hole through the firewall then just put a rubber grommet around it.

1986power

hope this question isnt as stupid as it sounds.. where can i find rubber gromets for that?

91 camaro racer

iTrader: (2)

any auto parts store should sell them. just figure out what size hole you will make then get a grommet that size


ex...http://www.autozone.com/autozone/acc...er=720110_0_0_

91 camaro racer

iTrader: (2)

and i dont consider any questions stupid. if you dont know the answer to something just ask. it is better to ask than to just guess and get it wrong.