[Wanted] lt1 intake modded for distributor
#1
Junior Member
Thread Starter
iTrader: (3)
Join Date: Oct 2006
Location: Monroe, LA
Posts: 96
Likes: 0
Received 0 Likes
on
0 Posts
Car: 76 Corvette Stingray
Engine: 350
Transmission: TH350
Axle/Gears: Stock
lt1 intake modded for distributor
I am going to try my luck on this one. I am looking to put an lt1 intake on my block instead of tpi... so, I was hoping someone had one that had already been modded for a distributor. I understand that there are more mods needed to make it fit right, but the distributor hole and spacer is the only part that makes me nervous, so before I just grab a stock one and hack away, I wanted to see if anyone happened to have one with this done.
Thanks
Thanks
#3
Supreme Member
iTrader: (1)
Join Date: Apr 2008
Location: Utah
Posts: 10,401
Likes: 0
Received 2 Likes
on
2 Posts
Car: 89 RS 89 iroc 87 firebird
Engine: 3.1 Turbo/ 355 twin turbo
Transmission: a4 w/ 4500 stall/ a4 / t5
Axle/Gears: strange s60 /w 3:42's
Re: lt1 intake modded for distributor
contact streetlethal he has a lt1 intake or atleats had on almost ready to go, not sure if he ever sold it or not.
he modified his differently then most though , he cut out the section were the dizzy would go then cut a sbc intake that had the dizzy hole so it fit exactly right into the lt1 intake .though i dont belive it was welded up yet.
if it needs to be welded it would be as simple as bolting it to a block lining up the dizzy piece droping in the dizzy to align everything and then tacking it in place. remove the intake and finish welding it up
he modified his differently then most though , he cut out the section were the dizzy would go then cut a sbc intake that had the dizzy hole so it fit exactly right into the lt1 intake .though i dont belive it was welded up yet.
if it needs to be welded it would be as simple as bolting it to a block lining up the dizzy piece droping in the dizzy to align everything and then tacking it in place. remove the intake and finish welding it up
#4
Junior Member
Thread Starter
iTrader: (3)
Join Date: Oct 2006
Location: Monroe, LA
Posts: 96
Likes: 0
Received 0 Likes
on
0 Posts
Car: 76 Corvette Stingray
Engine: 350
Transmission: TH350
Axle/Gears: Stock
Re: lt1 intake modded for distributor
I ended up buying one from aliceempire, but thanks for trying to help.
-Wes-
-Wes-
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
05-10-2023 07:19 PM