LTX and LSXPutting LT1's, LS1's, and their variants into Third Gens is becoming more popular. This board is for those who are doing and have done the swaps so they can discuss all of their technical aspects, including repairs, swap info, and performance upgrades.
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
Im using the 93 f body LT1 engine bay harness and the rest from my 92 rs 305 TBI.
I just want to the car to be able to run and drive, then Ill figure out the rest like the aldl stuff and get the speedo working. Im gona have the ecm sent to get the vats removed. But for now this is what I have and am hoping will get it running
For the LT1 harness
c100
PIN A-Power feed from injector fuse 9 going to a switched 12v source
PIN G-Power feed from ignition fuse 11 to a switched 12v source
PIN K-Power feed from injector fuse 10 to a switched 12v source
c210
PIN A-Starter 12v source to B4 C100 Starter wire(purple)
PIN B-ECM ground to ground
PIN C-ECM battery feed to A4 c100 constant 12v
C220
PIN J-Fuel Pump Relay Control to G4 of c100 Fuel Control gray wire
PIN F-Fuel pump feed too ????
C230
PIN G-Power feed from ecm ign fuse 5 to switched 12v
Is the computer from a '93 as well? If it isn't,you'll have to swap it out for a '93, if it is then all you need is a chip burned to take the vats out, most end up using a '94-95 PCM and harness since the '93's are a totally different beast.
yes the ecu and harness are from the same car, so in coming from someone who has done this before it will start up the first time if its wired as I showed?
