NW Indiana and South Chicago SuburbsLooking for club members to have gatherings, cruises, and to help each other out.
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
I went to put the frame connectors i have in today and my front subframe is smashed by the previous owner who looks to have lifted the whole car on a small lip and bent it. I dont feel like going knees deep into something that should be simple. so i am selling them
they are the box steel style ones that, yes unfortunately, require "modifying" the rear floor pan (aka bashing it in with a hammer). i bought these a while back off some one on here and never got around to installing them.....so i am just going to cage the car and use some easier to install connectors
so asking $50 obo, I have NO idea what i paid for them and i know it was more than $50, so let me know!!
NOTE I think they are competition engineering ones but i am not sure, the weld in style ones
__________________ Mike
I drive nothing with less than 350 cubic inches....except my Celica Best of a 13.50 @ 107 Its like myspace BUT for gear heads
Last edited by 91CamaroRS305; 07-10-2006 at 07:10 PM.
Is there any way to knotch out the connecter to avoid body smashing?
possibly if you are good at welding, there may also be problems with the exhaust, I never looked too far into it because of the shape my front subframe was in
