wa90formula350

I' m sure this posted some where but I could not find it. Late 80's roller 350, vorted heads, hei ignition, no computer, what is the timing spec?? I have it timed like a 70's 350 if I remember correctly and am now wondering if my carb issues are really timing issues.

Thanks

Rob

five7kid

iTrader: (14)

Quite often "carb" problems are actually ignition problems.

Vortec heads don't need quite as much advance as older SBC heads. 32 degrees total mechanical is usually all that's needed, vs. the 36 of the older heads.

Initial timing should be in the 8-12 range. And, you should have the vacuum advance hooked up.

wa90formula350

I was at 9, bumped it up to 12 and big difference, still carb fine tuning to be done but less of a hesitation and much better response. Thanks

Rob

85camarocrazee

iTrader: (1)

Mine is at 32 total. Dyno tuned and that was DEFINITELY the sweet spot!

wa90formula350

what is your initial timing at?

Quasi-Traction

I'm running 30-32 degrees of total timing. 10 degrees base.

Also running with the vacc pod on the distributor and both ports on my Double Pumper plugged. seemed to advance too much otherwise.

Also found with the Vortec heads a slightly hotter plug (Autolite 26's) did better after 1000 miles of mixed driving, then the Autolite 24's I had on there with traditional SBC iron heads.

wa90formula350

I'll have to see what plugs I am running and recheck my timing as well, thanks for the help

85camarocrazee

iTrader: (1)

I believe it was 10? Im not running a vac adv but would prefer to. Just havent gotten around to getting one on there.

MaNiAk86

iTrader: (2)

with my vortec setup i discovered that it needs alot of initial timing and only 32-34 total. i run 15 base timing with 33 total all in by 3000rpms and it seems to be happiest

ziggy89

what about sumthing with a dart iron eagle head
should i set the timing up for an old style head

evilemokid94

iTrader: (6)

So timing without the vac advanced on the hei distributer should be about 12* btdc? And 32 with the vacuum advance hooked back up?