Neutral Safety Switch
#1
Junior Member
Thread Starter
Join Date: Oct 2007
Location: Lebanon, Mo
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 Camaro Z28
Engine: 305 Carb
Neutral Safety Switch
how do i test or bypass the neutral safety switch? my car won't start and i have checked the starter enable relay and the vats work so the neutral safety switch is the next thing to check
#2
Supreme Member
iTrader: (3)
Join Date: Jul 2004
Posts: 2,989
Likes: 0
Received 5 Likes
on
4 Posts
Car: '91 Z28 convertible
Engine: TPI
Transmission: T5
Axle/Gears: 3.27 posi disc
Re: Neutral Safety Switch
I assume you have an automatic transmission?
There are six wires on the shifter connector (in your center console). Two of them are thick. Probably green and purple but can be of different colors too. You can just pull/cut them out of the connector and join them (solder or butt connector).
However, I would rather replace the shifter switch. I wouldn't want to accidentally start the car in drive or reverse. But that's just my opinion.
Lou
There are six wires on the shifter connector (in your center console). Two of them are thick. Probably green and purple but can be of different colors too. You can just pull/cut them out of the connector and join them (solder or butt connector).
However, I would rather replace the shifter switch. I wouldn't want to accidentally start the car in drive or reverse. But that's just my opinion.
Lou
#3
Junior Member
Join Date: May 2006
Location: Bedford, VA
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
Car: 83 Camaro
Engine: LT1 SD Mode 30lb/hr
Transmission: T56
Axle/Gears: 3.23
Re: Neutral Safety Switch
How about unplugging the Neutral start switch and making a pigtail to connect the two wires. It will only require two male spade connectors, and a small length of wire.
Its a little more involved than jamming a paper clip in the two large wire ends.
Have you tried starting it in both neutral and park?
Its a little more involved than jamming a paper clip in the two large wire ends.
Have you tried starting it in both neutral and park?
#4
Supreme Member
iTrader: (3)
Join Date: Jul 2004
Posts: 2,989
Likes: 0
Received 5 Likes
on
4 Posts
Car: '91 Z28 convertible
Engine: TPI
Transmission: T5
Axle/Gears: 3.27 posi disc
Re: Neutral Safety Switch
Yes, it will work, any way you can connect the two wires. I've even seen a wire cap on them!!!
Lou
Lou
Thread
Thread Starter
Forum
Replies
Last Post
Randomtask2
Interior Parts for Sale
5
09-10-2015 08:37 AM