kokamo

Hey guys, I have a very nice set of heads for sale. I just picked them up at the local machine shop. I had some big plans for these heads, but right after the day I purchased them, I ran accross a super deal on a complete 94 Z-28 with a LT1/4L60E drivetrain. Obviously these heads will not work on the LT!.....so, now they need to go.

These are a great set of Trick flow small block chevy cylinder heads-they have just been machined and ported at www.PortPros.com. No run time at all since the modifications. Heads were on an engine for about a month before they were reworked. They have Manly stainless steel swirl polished intake and exhaust valves. 2.020 IN and 1.600 EX. They are machined with a 5-angle valve job-bronze guide liners-new valve seals-the decks have been milled just enough to give a perfect finish for great gasket sealing.They have brand new comp cams springs-chrome moly retainers-chrome moly spring seat locators and locks. These head have canted valves and will support 500HP. These are a great set of heads for the street or strip. These heads will not disappoint. Heads have been CC'd at 63cc chambers and 205cc intake runners. Heads have 7/16" threadded holes for your screw in studs for the rockers.

These heads are for the GenI style motors with the old style (pre 86) intake manifold bolt holes. They can be used on a TPI or TBI engine with a little modification to your intake.

Asking $1000 plus shipping. Need to get them gone!

If you have any questions, please shoot me a PM.

Thanks!

Joe Hopkins

wesilva

iTrader: (35)

Are they the G1's or the G2's?

kokamo

They are the G1 heads witch have the 13* intake / 23* exhaust valve.

Forgot to mention that, sorry!

Joe

kokamo

Will take $1000 for these heads! Need to get them gone!