NO RICE

How do I wire starter, alternator, and distributor to start the engine on the stand?

I wanna do every thing while it's still out...

Thanks.

ede

not 100% sure but i think all you'd need to do is use a jumper cable from a battery to the starter. a wire from the selonoid to the coil. ground it to something. rig up some sort of radiator and hoses. and i believe the main thing would be to keep it from torqueing over on the engine stand. might want to consider fabracating a stand to hold the engine and bolt to the floor.

zz4mula

yeah,,I think I would want to start an engine a little closer to terra firma.

fb305svs

yeah i would think bolting it to the ground would be best, other wise its easy, dont worry about an alt and just use a switch to jump power from the cables to the starter....

hook up the ignition, and away ya go! just remember coolin is gonna be a situation too

Steve

------------------
88 Firebird Formula- deseased 2/9/99- 305 TPI, SLP 3 inch exhaust, SLP Intake runners, SLP cam, 3.45 BW disc brake posi, WS6, NOS, and all that good stuff, 13.~ sec 1/4 mile- hit by what else!?!? a FORD EXPLORER!!!!!!

86 Firebird, LG4, t-tops, slp 3 inch exhaust, catco cat, and a bunch of new/replaced stuff, open element, soon to come, 2 inch cowl hood, 3.42 posi disc rear from a 4th gen, and hopefully a 6 speed!
My Webpage- Battle of the birds, My own Thirdgen Page, still under construction, http://www.geocities.com/soares711/index.htm

NO RICE

"just hook up the ignition..."

that was part of my question... HOW DO I HOOK UP THE DISTRIBUTOR and the batery?

I already put exaust and radiator on and just need to wire it all up... and fire it up... I wanna break the cam and do the compression check wile it's out...

Thanks

zz4mula

you need a good 12 volt feed to the distributer. run your positive lead from the battery to the large stud on the starter solenoid. you can hook up a momentary switch to the smaller terminal of the solenoid. this will only kick the starter solenoid to drive the engine. many have used a wood handled screwdriver to do this as once the engine is running, there is no use for this connection. make sure you have a good return to the negative post of the battery.

NO RICE

but how do I wire up the HEI distributor?

merf23

Use a push on connector to the "BAT" terminal on the HEI(the one next to the "TACH" connection.) Use at least 16 gauge wire.
Make sure you use a switch to shut off the ignition, and an oil pressure gauge. Also you will need some kind of fan, a simple home box fan in front of the radiator works well.

I hope you fabricated a wide, low stand out of at least 2x2 0.125" steel which connects to the engine in 4 places or you are using very long wires to start this thing!