383 with vortec heads question
#1
Junior Member
Thread Starter
Join Date: Dec 2011
Location: sioux city iowa
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 formula
Engine: stock lo3 305
Transmission: 700r4
Axle/Gears: dont know
383 with vortec heads question
can i just put vortec heads on a 383 or do i have to machine anything
#2
Supreme Member
iTrader: (1)
Join Date: Aug 2007
Location: Bright, IN
Posts: 1,390
Likes: 0
Received 0 Likes
on
0 Posts
Car: '86 Bird, 96 ImpalaSS, 98 C1500XCab
Engine: LG4, LT1, L31
Transmission: 700R4, 4L60E, 4L60E
Axle/Gears: 3.73 Tors, 4.88 spool, 3.73 Eaton
Re: 383 with vortec heads question
The Vortec heads will bolt right onto any Gen 1 SBC (the steam holes for a 400 block would be the only consideration).
The head-to-intake bolt pattern is what's unique for Vortec heads.
The head-to-intake bolt pattern is what's unique for Vortec heads.
#3
Supreme Member
iTrader: (3)
Re: 383 with vortec heads question
They will bolt on to your block, but you will still have the same valve-lift limit (around 0.460") of the Vortec head unless that is corrected, and due to the relatively small CSA of the Vortec intake port you may be a little RPM limited (power wise) on a 383. It's not bad for street driving, but for best track results some careful porting would be in order.
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
08-20-2017 12:16 AM
L98GTA87
Engine/Drivetrain/Suspension Wanted
1
08-11-2015 06:55 PM
84z96L31vortec
North East Region
1
08-10-2015 08:27 PM