Can I tell 1.5 vs 1.6 roller rockers from measuring?
04-06-2002, 01:28 PM
#1
Senior Member
Thread Starter
iTrader: (2)
Join Date: Jul 1999
Location: St. Louis
Posts: 875
Likes: 0
Received 1 Like
on
1 Post
Car: RS
Engine: LS1
Transmission: T56
Axle/Gears: 9" for the ladies
Can I tell 1.5 vs 1.6 roller rockers from measuring?
I have some aftermarket aluminium boxy shaped RR's of unknown ratio.
Across the top they measure 2.75 inches total. From the pushrod end to the center of the stud hole they measure 1.25 inches. From center hole to rocker end they measure 1.5 inches.
Anyone know the ratio.
Across the top they measure 2.75 inches total. From the pushrod end to the center of the stud hole they measure 1.25 inches. From center hole to rocker end they measure 1.5 inches.
Anyone know the ratio.
04-07-2002, 01:16 AM
#3
Supreme Member
iTrader: (5)
Join Date: May 2001
Location: Naples, FL
Posts: 1,055
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Firebird
Engine: 383 stroker
Transmission: T-56
My Crane's are stamped right on the top and I thought all manufacturers stamped them on there somewhere. Maybe I'm wrong though
04-07-2002, 01:20 AM
#4
Supreme Member
Join Date: Dec 2000
Location: Springfield, MO, USA
Posts: 1,536
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 Trans Am, 1991 Firebird
Engine: 355 TPI, 3.1L V6
Transmission: 700R4 in both
Measure center hole to the push rod end. If that's 1.5 as well then I would say they are 1.5 roller rockers. I know with 1.6 you have to elongate the push rod slot so I would assume the cause of this is a 1.6 inch measurement from center hole to push rod end.
Thread
Thread Starter
Forum
Replies
Last Post
KO1
Engine/Drivetrain/Suspension Parts for Sale
16
10-15-2015 05:00 PM
15, 16, car, engine, inch, measure, measurement, measuring, measurments, meshurments, ratio, rocers, rocker, rockers, roller
