Bobby Suth

iTrader: (2)

will a 700r4 out of a truck work in a 89 camaro.if so which ones and what will i have to do

sablemaniac

you're better off getting one from another f-body if possible. if you get one from a truck you will have to change the tailshaft out anyways cause the truck doesn't have the torque arm bracket mounting provisions.

fireburdluvr85

that trans works just fine... change out the tail shaft from yours and put on the truck trans... also you need to take the speed sensor tone ring off the truck trans and put your stock gear on instead. but that depends on the yr truck trans you get....

Scorpner

iTrader: (4)

The one for my '85 was rebuilt and I wanted a post '87 version so I picked up a 700r4 from a truck. The casing is thicker and you might need to trim (1/2") of the outer edges if you have headers. Over all I'm very happy with it.

Apeiron

Make sure it's not a 4WD truck, and not diesel, and then change the tailshaft housing.

Pro Built Automatics

Add the Corvette servo and seals while it is out. This will prolong the life of the 3-4 clutch pack and the 2-4 band.

monsterjam5000

why cant it be a 4wd trans? can you still just change the tailshaft housing?

Apeiron

There isn't a tailshaft housing on a 4wd transmission, just a very short tailshaft, and the transfer case bolts to the rear of the transmission.

monsterjam5000

I was told that if you remove the transfer case off a 4wd, and remove the Tail shaft from a 2wd, that you can't tell what trans is what because the car the same. And that the transfer case off a 4wd is interchagable with th tail shaft off 2wd.

So the trans are not interchangable?

Apeiron

Not without disassembling them to replace the tail shaft. The shaft on the 4wd is several inches shorter than the 2wd.

Blk91Firebird

Yeah you would need to disassemble it and install an output shaft from a 2wd transmission. Which wouldn't be a big deal if you already had a 2wd transmission that was bad. Oh and you knew what you were doing. A automatic transmission isnt something you want tear into without a bit of knowledge

From what I found
The output shaft from a 4wd is 4 3/4" shorter than one from a 2wd

vetteoz

iTrader: (13)

10-29-2010
Your two years late for the party but

Blk91Firebird

yeah I know but if anyone else needed to know I figured it might could help

What ATSG manual did that come from? I poured through mine and didnt find anything like that