Transmissions and Drivetrain Need help with your trans? Problems with your axle?

What is the procedure to test 700r4 line pressure?

Old 01-31-2012, 03:38 PM
  #1  
Supreme Member

Thread Starter
iTrader: (9)
 
3rdgenmaro's Avatar
 
Join Date: Dec 2004
Location: Lincolnton, NC
Posts: 2,042
Received 18 Likes on 16 Posts
Car: 88 IROC
Engine: 97 5.7 Vortec LT4 hotcam
Transmission: 700 r4
Axle/Gears: 3.73
What is the procedure to test 700r4 line pressure?

I have searched around and cant find any set way to test the line pressure on a 700r4. Most information I found tried to direct you to the tvmadez website that from what I can tell no longer exists.

I have the gauge on order. I know the pressure port is located right above the shifter on the transmission. My problem is, what do I do? I figured test the pressure at idle in all shifter positions. Then test around 2000 rpm. But do you have to have it under load or can the car be on jackstands?

Any insight would be greatly appreciated. I dont want to do this blindly.

As far as the pressures go, I have seen stock charts, but since this transmission has a ProBuilt kit in it, I will probably call Dana to see what pressures I should be seeing. Maybe he will run across this thread.

Thanks
Old 03-22-2012, 01:27 AM
  #2  
Junior Member
 
cliffharris's Avatar
 
Join Date: Aug 2010
Location: Anaheim, CA
Posts: 22
Likes: 0
Received 0 Likes on 0 Posts
Car: 1986 Corvette
Engine: 5.7 liter
Transmission: Auto
Axle/Gears: 3.07
Re: What is the procedure to test 700r4 line pressure?

I have one of Dana's kits in my 700r4. These are the pressures I measured at idle:

Code:
 P        90 PSI
 R       130    
 N        90
OD        90
 D        90
 2       230
 1       230
The other test you want to do is increase the RPMs to about 1500 and pull the TV cable out as far as it will go. You should see pressures over 230 PSI in all gears.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
specialized
TPI
27
06-18-2022 09:26 AM
Andrew6.688
TPI
10
12-13-2015 10:59 AM
wayshegoes
Tech / General Engine
8
08-17-2015 12:00 PM
Kaweh
TBI
3
08-09-2015 02:54 PM


Thread Tools
Search this Thread
Quick Reply: What is the procedure to test 700r4 line pressure?



All times are GMT -5. The time now is 10:13 PM.