500+ HP Pump gas 355 - Third Generation F-Body Message Boards

IROCFAST · 05-11-2009, 03:20 AM

355 SBC late 80's roller block, Trick Flow Twisted Wedge G2 heads, stock nodular crank, Crower Pro Street cam (248-254@ .50---.545-.565 lift SFT),Speed Pro Hyper pistons (10.5:1), Powerhouse CR3 rods, Manley push rods, 1.6 Harland Sharp rockers. Drove it very little and recently went through and check the bearing and bores, all looked good, all new gaskets. It has a new double roller chain and the heads have been gone through and the springs were replaced. New balancer and flexplate. New Melling oil pump. Makes great power on pump gas. have all roller components except cam and pushrods if you wanted to put a hyd roller back in, desktop dyno says 522hp @ 6500 and 473ftlbs @ 4500. My best MPH with this engine was 120.7 @ 3450lbs on pump gas through the mufflers (5spd car) Asking $2300 obo neg

Thanks,
Brit
618-713-3170

IROCFAST · 05-11-2009, 03:21 AM

pic

ffemtm70 · 05-12-2009, 12:30 AM

Are you from southern Illinois? If so what part?

IROCFAST · 05-12-2009, 02:40 PM

Went to HS in Nashville, lived near Coulterville, lived in Belleville before I moved out here.

ffemtm70 · 05-12-2009, 05:44 PM

I am from Belleville as well. The wife got stationed out here at Luke after I got out of the military. I just saw the 618 area code and was curious.

IROCFAST · 05-13-2009, 12:28 AM

Did you hang out at Gateway much?

ffemtm70 · 05-13-2009, 12:33 AM

I actually used to work there as a Paramedic for Abbott Ambulance. I worked for a fire dept in Belleville.