South West RegionSouth West regional discussion board.
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
I live in Tucson, AZ and I have a 3.1 V6 RS Camaro. I just pulled/cut out a 40 series flowmaster muffler single outlet out of it... due to the sound, not my cup of tea.
I had researched and got many ideas on what to put in my baby. So now it came down to this...
Anyone know of a good shop/person/place/ect, here in Tucson, AZ where they can have them install it?
So far I found Midas...$175.00 to put it in but only with a stock muffler that they have to purchase.
Thank you guys and hope to hear some good info from my fellow tucsans..
I've always used exhaust works, they are on the east side at Sarnoff & 22nd, or Broadway & Swan. They have done some really nice aftermarket jobs to my cars, usually a little more $ but I found that I was a lot happier with alignment and such at completion. They also have most items in stock!!!
I've always used exhaust works, they are on the east side at Sarnoff & 22nd, or Broadway & Swan. They have done some really nice aftermarket jobs to my cars, usually a little more $ but I found that I was a lot happier with alignment and such at completion. They also have most items in stock!!!
Hey thanks for dropping in and for the reply. I'll give them a shot and see what they tell me.
I'll drop a reply that way people know what there prices are for our camaros and product...
try a chambered exhaust with a 3 inch internal pipe up to 26 inches long, and use it at the mid pipe then split them off as duals on the far side of the rear end.
try a chambered exhaust with a 3 inch internal pipe up to 26 inches long, and use it at the mid pipe then split them off as duals on the far side of the rear end.
Never thought of that...would 3' be alright for a V6 3.1? ...
And I'll check that out over there to see if anyone can do that...
