1 DwnCam

I need a full service shop to take a rolling chasis and X amount of months later pick up a fully working car, that is NHRA legal. Know of a place? Looking for somebody that is very familiar with chevys and can also do fabricating,electrical,mechanical,fuel system etc... My car needs to get done and I don't have the time to finish it.

__________________
This will give you an Idea.

http://www.cardomain.com/ride/2368130/1

Vrbancic Brothers Procharged 406
781.5 HP @ 6500
701 @ 5500
14 psi.

Dyno Don

Fast Eddies Race shop here in Orange...if you wan tall that done you better have about $20g

1 DwnCam

What's the going shop rate these days? 95% would be labor.

__________________
This will give you an Idea.

http://www.cardomain.com/ride/2368130/1

Vrbancic Brothers Procharged 406
781.5 HP @ 6500
701 @ 5500
14 psi.

Russ-So Cal

Dealers charge $95.00-$110.00/hour to change parts. I don't know what a fabrication shop would charge, but I suspect it would be at the higher end of the labor chart rather than lower.

Parrydise7

What Don said.

I don't know what "X" amount of months is, but they are going to take awhile. I took me about three or four months just to get in for a roll cage. The last time I was there, they were busy and they have multiple jobs going at the same time.

Good luck.

1 DwnCam

WOW that sure puts things into perspective. I need a new hobby.

__________________
This will give you an Idea.

http://www.cardomain.com/ride/2368130/1

Vrbancic Brothers Procharged 406
781.5 HP @ 6500
701 @ 5500
14 psi.