Suspension / ChassisQuestions about your suspension? Need chassis advice?
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
im going to purchase a new set of rear rims, i have 15x8s. im buyinbg 15x10s but dont know what backspacing i need. i read soemwhere 5.5 but i ve also heard 6? thanks
Depends on what brand of rim you intend to use. Many people use Weld rims. You don't get a 6" backspace option. 5.5" works fine and is the most common.
__________________
Hardtail Racing
All engine, no power adders! Bests: 9.029@150.45 (at altitude)
Theoretical sea level performance 8.623@157.05
not to hjack your thread but its kinda along the same lines would a 28 X 13.50R15 tire on a 15x10 wheel with a 5.5 backspace have any rubbing issues? will i need the quarter pannel lips rolled and need a bfh?
had 325/50/15s which compare to a 28/13.5 et street. all you really need to do is hammer the inner wheelwell where the lca is. and they will clear. they do stick out about 1/4 to 1/2 inch past the fender.
had 325/50/15s which compare to a 28/13.5 et street. all you really need to do is hammer the inner wheelwell where the lca is. and they will clear. they do stick out about 1/4 to 1/2 inch past the fender.
