Suspension / ChassisQuestions about your suspension? Need chassis advice?
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
I'm looking for a set of aftermarket spindles to replace the stock bulky ones. The car has tubular k member and a arms and everything is brand new powder coated except the ugly stock spindles. any one no where i can get some stock height?
Nothing available that's designed to use a factory setup. If you want a pretty, lightweight aftermarket spindle, you're going to have to completely change the front suspension.
junk yard set. then just clean them up as you like and refinish them. to bad ya didnt post this a few weeks ago. I just tossed a few sets to the trash.
__________________ 383 LT1 , Ported heads | Intake Drilled and running MSD Pro Billet Distrib.|Callies racemaster crank & rods | JE Pistons | Novi 2000 supercharger| Alloy Engineering Billet Strut Mounts | SLP Headers| TH400 w/ 10inch PTC 3500 converter | spohon adj. trq arm, cross member ,etc.. | 9bolt with 3.45's
* Gauging interest in selling supercharged 383 /th400 combo for a LSX T56 swap.* PM me if interested. Poss. Trade drive line for LSx t56 drive line*
if it were me, id get the racecraft ones.
they are 2" drop which means you can run stock springs and have correct geometry, while getting a lower stance and looking great.
then you can have them powdercoated to match what you already have.
. well they are actually rebuild, (sandblasted, cleaned, and painted) but basically look brand new. 
