Suspension / ChassisQuestions about your suspension? Need chassis advice?
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
So I'm putting an LS1 and tubular K member in my car. I want to go with the eibach pro kit, but my question is, Will it lower the car correctly since I'm going to be losing all that weight compared to a stock setup car? Just don't want to get them to find out that it doesnt lower the front end enough. Any help would be appreciated, Thanks
Also, Sway Bars? Which ones would you guys recommend?
alotta people like me install the prokit to see little to no drop due to sagging springs, i doubt you would drtop any,more than 1/2" i think the kit left me round 26.5" up front, you would probably be 1/2" higher than that, i trimmed my springs, which you could do aswell it will stiffen them up and with the 36mm front swaybar you would prob be good with a 23mm bar out back, that is if you trim off 1/2-2/3 coils and drop the front to around 26"
__________________ THE MODS Suspension: 18X9.5" hyper black c6 wheels with 265/40/18, 275/40/18 michelin PS2, AGR 12.7 to 1 steering box .225 valve, J&M strut mounts KONI Yellow sport/ Ground Control Weight Jacks#1,000/200, double adjustable lower control arms+ UMI LCA relocation brackets, UMI Panhard relocation "chassis side" with single adjustable UMI panhard, JEGS Panhard relocation "axle side". UMI SFC's. UMI tunnel mounted torque arm, 36/ 23 mm swaybars, Iroc wonderbar, Edelbrock 3 pt STB, Moog front end steering componets, Spohn bumpsteer kit. Intake: Ultimate T.B. + spacer, 14 X 3" open element 1.6 Comp Cams Roller rockers Exhaust: 1 5/8" Edelbrock shorty headers through 3" Flowmaster, carsound 3" converter.
