Ordering narrowed rear
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Sep 2001
Location: Miami, FL
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
Ordering narrowed rear
I did some searching and it seems like the general consensus is that the rear can be narrowed 1.5" per side without causing interference between caliper backing plates/calipers and the suspension mounting points. I don't have a stock length rear to look at (or any rear for that matter) to double check. Can anyone who's done this put my mind at ease before I order my new rear? Thanks.
#2
Supreme Member
iTrader: (5)
Join Date: Jan 2002
Location: Orland Park, IL
Posts: 13,619
Likes: 0
Received 3 Likes
on
3 Posts
Car: 1984 Z28
Engine: SLOW carbed ls
Transmission: TH400 with brake, 8" PTC converter
Axle/Gears: moser 9" 4.11
Re: Ordering narrowed rear
I'd call moser and ask the manufacturer
#3
Junior Member
Thread Starter
iTrader: (1)
Join Date: Sep 2001
Location: Miami, FL
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
Re: Ordering narrowed rear
That's assuming I'm ordering from Moser I am checking with the company but figured I'd ask here as well. I've seen some people talking about it but never saw a definitive answer. Going off memory I think I should be fine since I'm only going 1" per side. However, its been a long time since I've seen a thirdgen rear in person.
#4
Supreme Member
iTrader: (2)
Join Date: May 2002
Location: Everett, WA
Posts: 4,449
Likes: 0
Received 7 Likes
on
7 Posts
Car: 87' IROC
Engine: L98
Transmission: T56
Re: Ordering narrowed rear
This may help. Stock 9 bolt. 1" looks easily doable. The only issue I see is the stupid parking brake counterweight on the drivers side.
#5
Re: Ordering narrowed rear
Bumping this up. OP, what length did you end up going with?
Looks like with a different brake package or caliper clocking, I might get away with 2" a side. Maybe LT1 rear brakes? clock the caliper to the front and run some offset LCA's.
Looks like with a different brake package or caliper clocking, I might get away with 2" a side. Maybe LT1 rear brakes? clock the caliper to the front and run some offset LCA's.
#6
Supreme Member
iTrader: (2)
Join Date: Feb 2005
Location: West Warwick RI, postal code: 02893
Posts: 4,337
Received 55 Likes
on
41 Posts
Car: Building LS3, T56 Z28
Engine: LS3
Transmission: T-56
Axle/Gears: Moser/ 4.11
Re: Ordering narrowed rear
I too am looking at narrowing my rear. I want to run something nuts in the back like 20 x 12 and have very little backspacing so there is a crazy lip. I currently have a moser 12 bolt though. If I find any info about cost and fitment I will post up.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
05-10-2023 07:19 PM
Street Lethal
Power Adders
634
04-30-2019 12:14 PM