TBIThrottle Body Injection discussion and questions. L03/CFI tech and other performance enhancements.
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
That chart is somewhat out-dated. The STOCK injectors in the 305 TBI that I pulled off of a 305 truck were 55 lb/hr on a flowbench. Stock 350s are 61 lb/hr.
2.8 = 36 lb/hr
4.3 = 46 lb/hr
5.0 = 55 lb/hr
5.7 = 61 lb/hr
5.7 High Flow = 68 lb/hr
5.7 Vortec Van = 74 lb/hr
7.4 = Various ratings depending on year/application
i have new ones in my firebird and they have a red top on one side it says
RI279 and on the other side it says 7124? i have no idead what thats telling me?
I have a bunch of 5206, 4304, 5231 injectors and have had them all flow tested, etc.
5235206 typically flow at 650cc/min to 700cc/min @ 1bar which is 14.7 psi. This means that a 5206 (stock 5.7L) injector ranges in the low 60's for lb/hr.
Increasing fuel pressure (if pump can handle it) will increase flow rate and HP. Most stock fuel pumps dont do well about 14-15psi especially at WOT, etc.
I have some 5235206 injectors that flow at 720cc/min @ 14.7psi