91Bird305

http://cgi.ebay.com/ebaymotors/aw-cg...937799&r=0&t=0

Its an Edelbrock Performer TBI intake but its bored out to 2" and its only 51.00!!! Thats pretty cheap.

------------------
Eric Natzke
91 Firebird 305 TBI
"It Ain't Stock"
http://members.aol.com/j007golden/91firebird.html
For info on certain parts or mods go to the site below
http://members.aol.com/j007golden/modeval.html

Tas

isn't that Ghosst's? its not an edebrock. I don't think you can bore those out anyway. its from a Caprice.

------------------
-Tas
'89 Formula WS-6
[soon to be Torch Red with black hood and headlights =) ]

305, TBI, auto, 14x3 chrome flat based open element with K&N, Milodon 160* thermo, functional Formula hood, cross-flow Flowmaster, '99z28 rear pipes and tips....

Super GRK_Taz World
EFI & Intake Options
AOL IM: superGRtaz
ICQ 82881207

GhoSSt

iTrader: (1)

Yeah, its mine. I was slamming Edelbrock and Holley . Everyone thats installed one of those POS's has been disappointed. I was trying to offer a more viable, install friendly intake.

Kelly 'GhoSSt' Rosato

snflupigus

would you please measure with a metric ruler what the farthest measurement accross those bores is from the outer edge to edge. and from inside edge to edge, and maybe calculater what the exact centers of the 2" bores are without having to take mine off the car.?????

i need a measurement within .5mm

thanks

GhoSSt

iTrader: (1)

Snuf, we made these by bolting on a 670 tb, scribing the ports and then porting them with a die grinder. These aren't going to be exact measurements, just port matched. Are you SURE you want these measurements? If you prefer I can measure my Holley TB since its off right now.

Kelly 'GhoSSt' Rosato

snflupigus

ok that would be great. or both. even better. just tell me which are wich. i just want to get where the centers are at. im pretty sure they are the same centers as the little tb but not positive. thats all. just need some confirmation, without takin mine off. come to think of it. just measure the holley, since its the same as the rochesters design . those theives

GhoSSt

iTrader: (1)

Ummm... errr... since I didn't hear back from you, I went ahead and bolted it on yesterday.

I'll figure out something tho.

Kelly 'GhoSSt' Rosato

PS: 11cm outside to outside. 6mm between bores.

[This message has been edited by GhoSSt (edited February 04, 2001).]

snflupigus

hey thanks man, that what mine came out to be on my design. thanks for the confirmation.