Tech / General EngineIs your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
I just found a pair of 58cc angle plug chevy aluminun head off a 86 Corvette with 28000 miles. Part number is 14101128. Are these heads any good cause I can get them for $450.
__________________ 91 Camaro RS, V6 to V8 Swap.
78 350, headers, cam, new timing chain, edelbrock 600cfm carb and performer intake.
new intrax lowering springs, kyb struts and shocks
Originally posted by camarodude91 I just found a pair of 58cc angle plug chevy aluminun head off a 86 Corvette with 28000 miles. Part number is 14101128. Are these heads any good cause I can get them for $450.
let me put it this way.
i just got some like new Dart Iron Eagle heads, less then 6k on them for $500.
People will pay that much for the later d-port aluminum Vette heads, but the early (86 and 87) heads were just as bad as the iron heads they replaced. The only benefit was the higher compression. The d-port heads are good heads, and when properly ported, can be VERY good. Ligenfelter ported 113s will flow as well as cnc'd AFRs.
