Tech / General EngineIs your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
Im startin to plan the new motor to replace my Lo3. I would like to keep the whole TBI setup, emmissions and all, that way I can drive it daily in the summer even with the windows up. I have a stock bottom end with TRW forged pistons. Im gonna use some stock 76cc chambered heads, prolly with bigger valves and hardened exhaust seats. Id like to avoid any chip work, so Im thinking I should reuse the stock cam and add some roller rockers. I want to go with a centrifugal supercharger, have no idea what kind yet. My goal is high 11's in the 1/4, with slicks and a TH350. Can that setup work? Mabey Ill need a forged crank to run more boost to get into the 11's? Basicaly I want to put my TBI setup onto the 350 I have and add a supercharger. To me it sounds like it should work fine...
low;
is that front wheel horse power?
did i miss something?
just kidding dude!
5.8;
you should really design a blown motor from the ground up,might be better off selling what you have to help finance a project like that.
do you have to pass emissions where you are at now?if not i'd lose the computer!it's not a bad disconnect and the haynes manual actually has all the wiring diagrams to do it.all the gauges will still work.but i can't officially recommend this procedure.do it at your own risk
Eric
__________________ 86 camaro, 1984 383, pro topline vortecs with all comp.components,stainless valves, scat crank,wiseco forged pistons,9.5:1,6"scat I beam 7/16" capscrew rods,comp xs282s, performer rpm, 750 proform vac sec, msd in cap coil/module, no computer,hooker coated 2460's w 6767 y pipe,AJE K-member & a arms, coil over kyb agx,700r4,pioneer shift kit,corvette servo,2600 stall,'92 disk 10 bolt,
3.42 posi, poly suspension , hotchkiss lca's,275-60/15 mt et street radials on 8" weld pro stars
Last edited by SLEEPER 86; 05-08-2005 at 02:04 AM.
I would read this thread and PM these guys about your project. Boosting a TBI system is not just plug and play. It takes some special tuning and planning.
