Tech / General EngineIs your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
So i'm about to order all my parts up , thanks for the help selecting them ,including a XE 274 cam and i see on ebay that a guy living close to me is selling the following kit
Now living in the U.K parts rarely come up on ebay so it might be a good buy.
Any of you guys used this cam before ? its to go in a 350 with forged pistons / connecting rods , block bored .030" over , crank ground .010" under. I will be using the edelbrock RPM heads so the cam lift wont be a problem. Loopy idle is also not a problem
Not the same. This Lunati cam is quite a bit bigger.
more intended for a high compression ratio drag or circle track motor running a single plane intake and open headers.
Very rough idle, very low manifold vaccuum. Pass.
email the seller and have him clarify the actual cam part number or grind number.
if it is Lunati number 00012 these are the specs.
HYDRAULIC, Fair idle. Good street street/strip cam. Needs headers, gear and converter. 2500-6500 300°
300° 246°
246° .515"
.515" .343"
.343" 108° Sep
104° Int C/L 19°BTC 47°ABC /
55°BBC 11°BTC 00012 00012LK HYD
it is simular to Comp Cams 292H magnum
it is a good step more radical than the XE274H
Definatly needs a high 3500rpm stall converter, and 4.10's
use with 10:1 + compression and a 750 with a Vic JR intake.
