best way to clean ground terminals???
#1
Supreme Member
Thread Starter
iTrader: (2)
Join Date: Nov 2006
Location: Connecticut
Posts: 1,698
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1987 Camaro, 1986 Trans AM
Engine: V6 2.8 multi-port and V8 5.0 FI
Transmission: 5-Speed and Automatic
Axle/Gears: no idea
best way to clean ground terminals???
i think i may be having ground problems
to narrow it down i want to clean behind the cylinder head and where the negative cable bolts int front of the engine block
but clean it with what? i can see oil deposit on the engine block of 20yrs of use and the cylinder head is a pain to get to with so many wire harnesses in the way but i want to spray taht down with something and take a wire brush to it
any suggetions?
to narrow it down i want to clean behind the cylinder head and where the negative cable bolts int front of the engine block
but clean it with what? i can see oil deposit on the engine block of 20yrs of use and the cylinder head is a pain to get to with so many wire harnesses in the way but i want to spray taht down with something and take a wire brush to it
any suggetions?
#2
Senior Member
iTrader: (1)
Join Date: Jul 2007
Location: MA
Posts: 1,141
Likes: 0
Received 2 Likes
on
2 Posts
Car: '87 IROC/'68 SS
Engine: 5.7L/350
Transmission: 700R4/Muncie 4-spd
Axle/Gears: 3.27 9 bolt / 3.31 12 bolt
Re: best way to clean ground terminals???
i think i may be having ground problems
to narrow it down i want to clean behind the cylinder head and where the negative cable bolts int front of the engine block
but clean it with what? i can see oil deposit on the engine block of 20yrs of use and the cylinder head is a pain to get to with so many wire harnesses in the way but i want to spray taht down with something and take a wire brush to it
any suggetions?
to narrow it down i want to clean behind the cylinder head and where the negative cable bolts int front of the engine block
but clean it with what? i can see oil deposit on the engine block of 20yrs of use and the cylinder head is a pain to get to with so many wire harnesses in the way but i want to spray taht down with something and take a wire brush to it
any suggetions?
#3
Re: best way to clean ground terminals???
just what i was thinking.. some solvent and a wire brush and go to town.
you can d/c the wires too if they get in the way.. shouldn't be too hard to re-connect um, gl
you can d/c the wires too if they get in the way.. shouldn't be too hard to re-connect um, gl
Thread
Thread Starter
Forum
Replies
Last Post