Tech / General EngineIs your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
I have a 92 Z28 with the 5.7 TPI. The motor needs rebuilt, so I thought I'd put a little performance upgrade in it. Has anyone out there ever used the Comp Cams XR264HR cam, part no. 08-501-8? If so, any issues using the stock computer, stall, etc?
thats a nice cam, your stock heads will not support the lift even with stock rocker arms. youll need to have your car tuned or burn your own prom since since its speed density. Your stock stall will work fine.
would you recommend dropping down a level in cam? I am new to computer controlled motors, and want to make sure I don't get in over my head on expenses.
to be honest I dont know alot about the speed density other than they are alot more sensitive to change than maf. From what I understand any decent cam worth the time and money for a swap is going to need a program. If anything I would go to a 269hr 12. The car will still be drivable just not as enjoyable as it can be with a tune.
I thought as long as you stayed under.500 lift and replaced the springs with the proper ones in the cam kit all would be fine in a L98 5.7 TPI?? Explain "heads wont handle the lift"??
I run a 388 with fast burn alum heads, comp XE262 cam, 10:1 compression, 52mm T-body in front of a modified stock plenum & runners on top of a Scroggin's Dickey High Flow TPI intake, and out SLP 1-3/4" headers.
Idles and sounds pretty much stock until throttle opens up, even with the stock exhaust. Tune was modified only for 30lb injectors, timing, and idle.
as an update to this thread, I went ahead with the xr264hr cam in my car. I also installed roller rockers, had the heads and intake ported and installed headers. Still have to get a tune on it, but managed to get it all buttoned up before winter hit. Will try and finish the project up in the spring with a tune to fit the motor. Seems plenty strong even without a tune on it.
