Tech / General EngineWhy is my car making that sound? My car won't start! Combination questions? Don't see a board for your problem or have other technical or engine specific questions? Post them here!
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
hey guys..im thinkin about gettin some new heads for my sbc...but its got alotta miles on it..and i heard bad things if i was to swap out the heads for some new alum ones..But is it true that i could blow up the bottem end?..its got 171k..but runs very solid
thx guys
This ad is not displayed to registered members. Register your free account today and become a member on ThirdGen!
Sponsored Links
Registered users do not see this ad. Click here to register for free!
Just clean ur deck really good, Honestly, you should have it machined but you can get away with just cleaning it real good.
Dont see how aluminum heads will blow up your bottom end??? Are they small chamber heads? Just dont buy heads that will make anymore than 11to1 compression otherwise your motor will ping unless you run race gas in it.
Get a head in the 64cc range, Witch if your car is a l98 it should have iron 083 64cc heads allready on it. But an aftermarket set of afr 190's will wake it up like no other!!!
thanks for the reply guys!....but yeah..i have lb9 305..and the stock heads need valve guide's to be done...but i rather throw in a nice size cam and set of the trick flow 56cc alum heads on there...so u guys think it will be fine along as i clean up the surface area were the heads sit(pistons etc)
My bad man, never had a 305 so I never new the actual name.
I personaly would not waste my money on a 305......but thats just me. 350 blockes are a dime a dozen and cheeeeep as crap, I mean really, you could spend a 1000 dollars on a set of heads and everything that comes along with it, or you could spend 300 dollars on a 350 block and be further ahead??? If my understanding is correct the tpi unit is the exact same for the 305 just smaller injecters, and some computer tuning....
But the heads your wanting to run will definetly wake it up thats for sure, wont hurt the bottom end at all.......unless you spray, or wing it up to 8000 rpms all day long.
Do a compression check on all cylinders first. If they test good, change the heads, cam, and timing gear set together. Your pistons will be covered with carbon so clean them off while you're in there.
I would not worry about blowing up the bottom end. If you raise the compression there might be some more blowby and therefore higher oil comsumption. But then again there may not be any.
