I have a low mileage stock car that was throwing a MAF code this is the 3rd MAF in 11K. So before put 3 rd one in I cleared code and left the second one in and I went to get on it and car fell on its face stalled out. I could not start car that night, I tested for fuel pressure at rail and there was. I pulled a plug and checked for spark it was there, the car would crank but not run. I left it and next morning to be sure I brought 3 gallons of gas to be sure I had gas in case gage was dead it said last night I had 1/4 of tank and when I opened gas cap i had serious vapor lock. I then disconnected MAF and battery for a couple minutes cleared codes and car started right up. I left MAF disconnected and drove home. Next day I then put in new MAF and car started right up. Ran it for twenty minutes and I shut it off no codes seemed fine. I then went to start and it would not. I checked fuel pressure and it had 42 pounds of pressure on gauge. Next day I was having it towed to mechanic and it started ran it for ten minutes and then trying to load on flatbed it died n would not start. Mechanic confirmed spark and fuel pressure he thought for sure computer. Pulled one in it out and saw it was not original computer and had a hypertech chip I knew that 160 thermostat is in it. So third computer in 11K car still did not fix car. Thoughts????