Drilling blind oil passage hole
#1
Senior Member
Thread Starter
Drilling blind oil passage hole
Have a 1975 350 and am converting it to TPI. When I went to install the oil pressure sending unit, the hole above the oil filter is threaded but blind. I am assuming that is where the sending unit would thread into? Or is the it non drilled hole lower and to the left?
Can I just use a small bit and drill through into the passage? If not I will just get some fittings and run it off the hole behind the intake manifold.
Can I just use a small bit and drill through into the passage? If not I will just get some fittings and run it off the hole behind the intake manifold.
#2
Supreme Member
iTrader: (1)
Join Date: Sep 2005
Posts: 26,050
Received 1,672 Likes
on
1,269 Posts
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: Drilling blind oil passage hole
No that is not the oil pressure sender hole. That's the boss for the clutch Z-bar pivot ball.
I can't see enough of the block to be sure, but the undrilled spot may be where it goes. The bolt hole CERTAINLY is not, however.
I can't see enough of the block to be sure, but the undrilled spot may be where it goes. The bolt hole CERTAINLY is not, however.
#3
Senior Member
Thread Starter
Re: Drilling blind oil passage hole
I went ahead and found an assortment of brass fittings to make the dash gauge sending unit/OPSU/mech. gauge work off the oil hole behind the intake. It is easier that way.
Thread
Thread Starter
Forum
Replies
Last Post
Hotrodboba400
Firebirds for Sale
3
12-10-2019 07:07 PM