Tech / General Engine Is your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!

Two new issues - speedo & idle

Thread Tools
 
Search this Thread
 
Old 08-15-2014, 06:00 PM
  #1  
Member

Thread Starter
 
Fronzizzle's Avatar
 
Join Date: Jul 2011
Location: Augusta Township, MI
Posts: 450
Received 0 Likes on 0 Posts
Car: 1985 IROC-Z
Engine: 383
Transmission: 700R4
Axle/Gears: 3.73
Two new issues - speedo & idle

Hello all,

Over the last week, I've put about 200 miles on my car, making about...400 or so since I rebuilt everything. The entire interior including gauges, rebuilt 383 stroker with HSR, complete trans rebuild, etc. My car is a 1985 with the ECM/MAP system out of a 1990, and I have a full set of Autometer Cobalt gauges. The transmission is the 700R4.

After driving it so much, including a varying speeds & and getting stuck in the Woodward Dream Cruise traffic, I found two new items to worry about/fix. I don't know where to start for either.

* Every once in awhile, mostly at highway speeds or faster (60 mph or higher), the speedometer will jump up and down about 5 miles an hour even though the speed of the car doesn't change. This only lasts for maybe 3-4 seconds at most, then goes right back to acting correctly. This isn't a big deal, but more of an inconvenience.

* A bigger issue. I drove the car a ton, started and shut it off a ton today at the Dream Cruise. I had absolutely no issues with the idle, it was steady at right around 1,000 RPM. After driving home (about an hour, maybe 20 miles), I put the car in park and noticed that it was idling awfully fast - close to 2,000 RPM. When I put the car back in gear, the idle went back down to around 1,000 but then in park, jumped back to 2,000. I'm more concerned about this as it seems it could be something more serious - not sure what causes an idle to change like that. Is it possibly related to the TV cable?
Old 08-18-2014, 10:02 PM
  #2  
Member

 
el_muerte's Avatar
 
Join Date: Nov 2005
Location: Edmonton, AB
Posts: 428
Likes: 0
Received 0 Likes on 0 Posts
Car: '87 Z-28
Engine: LT1-topped 400
Transmission: T56
Axle/Gears: 3.42
Re: Two new issues - speedo & idle

1. Get your speedo cable lubricated. Make sure it didn't get pinched or have any sharp bends since the engine was out.

2. Idle could be a number of things. Vacuum leaks are a good place to start. Did you set the minimum idle air after you first rebuilt the engine? Idle speed may need to be adjusted as the engine break-in progresses. I wouldn't worry about the speed going from 2000 in neutral to 1000 in drive; if you're using the stock torque converter it has a pretty low stall speed and would therefore drag the engine speed down quite a bit if it is idling high.
Old 08-19-2014, 07:16 AM
  #3  
Member

Thread Starter
 
Fronzizzle's Avatar
 
Join Date: Jul 2011
Location: Augusta Township, MI
Posts: 450
Received 0 Likes on 0 Posts
Car: 1985 IROC-Z
Engine: 383
Transmission: 700R4
Axle/Gears: 3.73
Re: Two new issues - speedo & idle

Thanks for the advice.

I thought before - I can't remember why now - that I had a vacuum leak. I wasn't able to find one at that time, I'll look again.

Some more information: On Saturday, I went out and started the car and the idle was fine, back to normal. Whatever it was or caused it went away (at least temporarily).

I think I might have an electrical/ground problem. I didn't associate the idle with it, but at the same time that was going on my passenger window wouldn't roll up. After I pulled the car in the garage, I shut the car off, then turned the key back on and the window rolled up fine. I've had some other intermittent symptoms, too - I'm going to go through and check all the main ground straps and points to make sure they're all good.
Old 08-19-2014, 07:17 AM
  #4  
Member

Thread Starter
 
Fronzizzle's Avatar
 
Join Date: Jul 2011
Location: Augusta Township, MI
Posts: 450
Received 0 Likes on 0 Posts
Car: 1985 IROC-Z
Engine: 383
Transmission: 700R4
Axle/Gears: 3.73
Re: Two new issues - speedo & idle

Oh, also - it's not a factory torque converter. It is a Vigilante 2800 stall.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
specialized
TPI
27
06-18-2022 09:26 AM
Street Lethal
Power Adders
634
04-30-2019 12:14 PM
Wade787b
TPI
2
09-29-2015 01:15 PM
bamaboy0323
Tech / General Engine
25
09-03-2015 06:07 AM
IroczFan
Carburetors
1
08-18-2015 05:19 AM



Quick Reply: Two new issues - speedo & idle



All times are GMT -5. The time now is 10:15 PM.