Tech / General EngineWhy is my car making that sound? My car won't start! Combination questions? Don't see a board for your problem or have other technical or engine specific questions? Post them here!
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
Some one along the line mentioed some bits that could be used for porting heads with a Dremel. They were a smaller diameter shaft than the die grinder bits. Anyone know?
Anyone ported with a dremel? Thoughts?
This ad is not displayed to registered members. Register your free account today and become a member on ThirdGen!
__________________ Colin Finkle
'87 Camaro SC
Greens' Thoughts on Life for the Month- (Number 3)
Just something for the moderators to chew on... After the 'First Near Death Experience" fiasco, I came away quite annoyed. The moderator said that I should have PMed him or the site in general. I would have gladly, but he blocked it without any message of why, so I had no such chance. I wouldn't want to face the hurt, and remain nameless, too... But if you are going to close ANY post, please, give the person a chance to take it up with you. Message before you close it..!
Do disrespect, just a suggestion... (Most of you guys do anyway!)
Sponsored Links
Registered users do not see this ad. Click here to register for free!
Just, bumping it up in hopes someone knows a cartrige cutter for the Dremel.
Pleez!!!:hail:
__________________ Colin Finkle
'87 Camaro SC
Greens' Thoughts on Life for the Month- (Number 3)
Just something for the moderators to chew on... After the 'First Near Death Experience" fiasco, I came away quite annoyed. The moderator said that I should have PMed him or the site in general. I would have gladly, but he blocked it without any message of why, so I had no such chance. I wouldn't want to face the hurt, and remain nameless, too... But if you are going to close ANY post, please, give the person a chance to take it up with you. Message before you close it..!
Do disrespect, just a suggestion... (Most of you guys do anyway!)
Originally posted by GreenProStreet Some one along the line mentioed some bits that could be used for porting heads with a Dremel. They were a smaller diameter shaft than the die grinder bits. Anyone know?
Anyone ported with a dremel? Thoughts?
I used a carbide bur in my dremel with the cable. I ported both heads, intake, runners, and plenum with 1 bit. I got it at a farm store near me for less than 20.00. Dremels are just as fast as the die grinders , and a LOT less noise. Check some industrial supply hardware stores for the carbide bits they work much better than stones.
87 GTA 355/700r4
