Tech / General EngineIs your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
on a 14x3 dual snorkel air intake,how much is air flow hindered with a 1/2" drop base
is worth worrying about? i know it drops the filter down a slight bit and then the incoming air has to flow over the 1/2" bump up inside b4 emtering the tbi..........gimme your thoughts
you shouldn't lose any from the last test i seen. i believe it was car craft or hot rod did an air filter test and the one that suprisingly did the best was the drop base air cleaner. not that it says the drop base is the best, but i wouldn't expect any loss due to it.
__________________ 2006 Silverado 1500 RCSB 2wd 5.3L 345RWHP/341RWTQ. Comp Cam 222º/224º .566/.568 112LSA, 2600 stall, 3.73 gear (stock), Detroit Locker, 160º thermostat, Corsa Sport cat back, Outlaw cold air intake, Pacesetter long tubes.
13.59@100.34 2.04 60' In full street trim with no weight reduction and on the 20's.
2006 Silverado 1500 RCSB 2wd 5.3L 345RWHP/341RWTQ. Comp Cam 222º/224º .566/.568 112LSA, 2600 stall, 3.73 gear (stock), Detroit Locker, 160º thermostat, Corsa Sport cat back, Outlaw cold air intake, Pacesetter long tubes.
