for salle: Engine parts, Aluminum flywheels and scattershield
I have a BUNCH of engine parts for sale- I have changed direction and sold my Players car. I am looking to add to my NEW car fund!
350 SBC 2-piece rear main seal, forged steel crank, std/std- polished ready to go $250
350 SBC Eagle cast steel crank 1 piece rear main seal std/std new in box drilled throws $225
350 SBC Eagle cast steel crank 2 piece rear main seal std/std new in box drilled throws $225
The EAgle cransk are 10 lbs lighter than stock and stronger!!!!!
Findanza aluminum flywheel for 1 piece rear main seal 153 tooth NEW $300
Findanza aluminum flywheel for 2 piece rear main seal 153 tooth NEW $300
14101128 Chevy Aluminum corvette heads stock, need rebuilding $300
USED Lakewood scatter shield for 3rd gen Camaro with hydraulic clutch and t-5 (tilted) or T-10 straight up $275
350 2 bolt main, 2 piece rear seal, bare block, bored .030 over all machine work done ready to assemble, hot tanked, new freeze pugs, ARP main studs, and new cam bearings etc $400
USED Kieth black Hyper pistons dished +0.030 hung on 5.7 rods that were rebuilt and have ARP rod bolts and balanced $150
USED Reconditioned 5.7 rods combo fo X and pink rods, ARP bolts low run time-$75
Edelbrock Performer RPM intake manifold $60
M/T cast aluminum finned valve covers $40
Moroso valve covers- were gold, now wrinkle black $40
Complete TPI setup from my 1988 Players car, It has Accel 24lbs injectors and a JET adjustable fuel pressure regulator, MSD Coil, ECM everything, harness is a bit rough but, complete $300
Make me some offers, stuff is collecting dust!!
Steve
tel: 905-918-2633
Near the GTA
Re: for sale: Engine parts, Aluminum flywheels and scattershield
I have a BUNCH of engine parts for sale- I have changed direction and sold my Players car. I am looking to add to my NEW car fund!
350 SBC Eagle cast steel crank 2 piece rear main seal std/std new in box drilled throws $225
The EAgle cransk are 10 lbs lighter than stock and stronger!!!!!
14101128 Chevy Aluminum corvette heads stock, need rebuilding $300
USED Lakewood scatter shield for 3rd gen Camaro with hydraulic clutch and t-5 (tilted) or T-10 straight up $275
350 2 bolt main, 2 piece rear seal, bare block, bored .030 over all machine work done ready to assemble, hot tanked, new freeze pugs, ARP main studs, and new cam bearings etc $300
USED Reconditioned 5.7 rods combo of X and pink rods, ARP bolts low run time less than 20 hours on them-$75
Moroso valve covers- were gold, now wrinkle black $40
Complete TPI setup from my 1988 Players car, It has Accel 24lbs injectors and a JET adjustable fuel pressure regulator, MSD Coil, ECM everything, harness is a bit rough but, complete $350 MANUAL transmission ships
Make me some offers, stuff is collecting dust!!
Steve
tel: 905-918-2633
Near barrie
