05-27-2005, 02:19 AM
|
#1 |
| Senior Member
Join Date: Sep 2004 Location: Charles County, Maryland
Posts: 1,854
Car: 89 TA, 79Z28, 88K1500 TPI swapped Engine: 350 HSR, 350TPI Transmission: 700R4 w/ Raptor 5X 9.5" converter Axle/Gears: 3.73 8.5" ring 10 bolt | What size OD are ends of MAF sensor? Making custom intake and don't have sensor handy
| Hi, can anyone tell me what size OD the MAF sensor is on each end, where the rubber duct slides over? I am going to be collecting parts to make a custom CAI, but the car is out of state at the moment and I can't measure the sensor. I am probably going to get 3" galvanized steel electrical conduit or exhaust pipe and mig up an intake, then paint it, and I need to know if the MAF is also 3" or if I have to use reducers to mate to the 3" tubing. | | |
__________________
1989 Trans Am, 1979 Z28 w/ Holley Stealth ram and MAF '165 ECM, 1988 Chevy K1500 w/ L98 and TPI swap, 2003 Mercury Marauder, 2004 Taurus SEL |
 
|  |
