Swapping injectors, what tools do I need? - Third Generation F-Body Message Boards

BigWhiteGTP · 03-19-2006, 04:06 PM

I read that I need a special tool to remove a pin or clip? What is it's name? And can I buy the O-rings at Autozone or Checker? Anything else that I will need?

sam · 03-19-2006, 04:17 PM

Well when i did mine i had to remove the plenum and runners.

Then you need to rmove the fuel rail with the injectors...

Going to take some time.

My biggest problem was breaking tools as i tries to unbold the runners. Then i got my hand on a torch and was way easier to unbolt.

You will need to get orings for the fuel rail. they were cheaper at GM

/Sam

BigWhiteGTP · 03-19-2006, 04:21 PM

Thanks, I have to remove the intake to replace the gasket underneath. So the O-rings are for the fuel rail not the injectors? What tools did you break unbolting the runners?

sam · 03-19-2006, 04:41 PM

I would get a set of orings for the injectors and 2 oring for the fuel rail

BigWhiteGTP · 03-19-2006, 04:54 PM

So 3 sets total. How much do they normally run at a GM Dealership?