TPITuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
Does anyone know the stock diameter of the throttle body and runner holes on a TPI plenum (out of an 85 305)?
Ive got the plenum ready to polish it and I want to see if it has been ported since the previous owner installed aluminum SLP runners and an aftermarket throttle body.
Also, I have seen cases where people have (successfully) ported their own plenums using a sharpie marker as the outline and a dremel tool for the porting. Will this work fine if done right? If this can be pulled off I'd much rather take the DIY route than send the plenum off to be ported.
