TPI 350 engine specs
03-06-2002, 02:34 PM
#1
Senior Member
Thread Starter
Join Date: Jun 2001
Location: Northern Kentucky
Posts: 726
Likes: 0
Received 1 Like
on
1 Post
Car: 1991 Z28
Engine: L98
Transmission: 700R4
TPI 350 engine specs
I was wondering if anyone knows where I can find engine specs for the L98? I am planning a cam and head swap very soon, and I was wondering where I could get some info on that motor. I have some stock cam info, somebody please check this for accuracy please.....
Lift .413 INT .428 EXH
Duration 202 INT 207EXH
Lobe seperation 114.5
rocker arm ratio 116/116
I was also curious who makes the best intake runners? And finally, If I get say, Edelbrock heads, will I have to port match the intake for them to fit? Any additional info would be GREATLY appreciated. Thanks guys...
Mike Estep
Lift .413 INT .428 EXH
Duration 202 INT 207EXH
Lobe seperation 114.5
rocker arm ratio 116/116
I was also curious who makes the best intake runners? And finally, If I get say, Edelbrock heads, will I have to port match the intake for them to fit? Any additional info would be GREATLY appreciated. Thanks guys...
Mike Estep
03-08-2002, 11:05 AM
#2
Supreme Member
Join Date: Aug 2001
Location: Orygun
Posts: 2,747
Likes: 0
Received 0 Likes
on
0 Posts
Re: TPI 350 engine specs
Originally posted by KYL98
I was wondering if anyone knows where I can find engine specs for the L98? I am planning a cam and head swap very soon, and I was wondering where I could get some info on that motor. I have some stock cam info, somebody please check this for accuracy please.....
Lift .413 INT .428 EXH
Duration 202 INT 207EXH
Lobe seperation 114.5
rocker arm ratio 116/116
I was also curious who makes the best intake runners? And finally, If I get say, Edelbrock heads, will I have to port match the intake for them to fit? Any additional info would be GREATLY appreciated. Thanks guys...
Mike Estep
I was wondering if anyone knows where I can find engine specs for the L98? I am planning a cam and head swap very soon, and I was wondering where I could get some info on that motor. I have some stock cam info, somebody please check this for accuracy please.....
Lift .413 INT .428 EXH
Duration 202 INT 207EXH
Lobe seperation 114.5
rocker arm ratio 116/116
I was also curious who makes the best intake runners? And finally, If I get say, Edelbrock heads, will I have to port match the intake for them to fit? Any additional info would be GREATLY appreciated. Thanks guys...
Mike Estep
SLP makes the best runners IMO because you can always go siamesed with them later. Your cam specs are close enough, a degree or two off on duration is no biggy, LSA is 114, lift is about what you said, maybe a little more.
Thread
Thread Starter
Forum
Replies
Last Post
NinjaNife
Tech / General Engine
27
08-23-2015 11:49 AM
