T-56 Shifter Ball with offset button
#1
Senior Member
Thread Starter
Join Date: Oct 2000
Location: Stuart, Florida USA
Posts: 524
Likes: 0
Received 0 Likes
on
0 Posts
T-56 Shifter Ball with offset button
Has any one seen the ad for a new Hurst or Mr Gasket shifter ball that has the button to the side and not on top like normal. If so, could you please post what mag you found it in. I cannot find it again.
TIA
Mark
TIA
Mark
#3
Member
Join Date: Feb 2002
Posts: 243
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Z28
Engine: 305 TPI under 14 psi
Transmission: aftermarket T56
Axle/Gears: Moser 12 bolt 3.08 gears
If this button is for the reverse lockout solenoid forget the button. Just wire it up to the stop light switch, so whenever you hit the brakes it will allow you to shift into reverse. Just remove the drivers side sill plate and pop the plastic harness protector appart. In that group of wires there will be a light blue one, which is connected to the stop light switch.
#4
Senior Member
Thread Starter
Join Date: Oct 2000
Location: Stuart, Florida USA
Posts: 524
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by YenkoZ28
If this button is for the reverse lockout solenoid forget the button. Just wire it up to the stop light switch, so whenever you hit the brakes it will allow you to shift into reverse. Just remove the drivers side sill plate and pop the plastic harness protector appart. In that group of wires there will be a light blue one, which is connected to the stop light switch.
If this button is for the reverse lockout solenoid forget the button. Just wire it up to the stop light switch, so whenever you hit the brakes it will allow you to shift into reverse. Just remove the drivers side sill plate and pop the plastic harness protector appart. In that group of wires there will be a light blue one, which is connected to the stop light switch.
Mark
#6
Supreme Member
Join Date: Feb 2010
Location: Orlando
Posts: 1,446
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1991 Camaro Z28
Engine: 357, Canfield heads, solid roller,
Transmission: Upgraded 03 Cobra T56
Axle/Gears: 9" 3.50 gears and Detroit Locker
Re: T-56 Shifter Ball with offset button
Something tells me that in the last 7 years, the OP has made up his mind already
Thread
Thread Starter
Forum
Replies
Last Post
sjorgens
Suspension and Chassis
7
10-01-2015 07:54 PM