02-01-2004, 11:19 PM
|
#1 |
| Senior Member
Join Date: Jul 2001 Location: Western PA
Posts: 995
Car: 1986 IROC-Z Engine: L98 Transmission: TH-700R4 | What VSS sensor connects to this tailshaft?
Below is a picture of the output shaft of an NP205 transfer case, which I'm swapping into my Jeep Wrangler. I'm doing a full Chevy driveline, with a 350 TBI motor.
Obviously, the t-case is set up for a mechanical speedometer. I have both an electric and cable-driven speedometer available, but I'd much rather use the electric gauge.
If I went electric, I'd ideally need to find a sensor that would bolt right up to the threaded mount. I could then run a VSS buffer into the ECM, and the rest of the signal into the speedometer. Everybody would be happy.
I saw this post, in which a Grand Wagoneer's VSS sensor is discussed -- but I don't know if it'd bolt up to my GM transfer case. The VSS sensor in my Wrangler is removable, but it's not threaded onto the gear (it's bolted in place like a distributor).
Any thoughts on how I can do this electrically, without using one of those expensive intermediary boxes? | | |
__________________
1986 Camaro IROC-Z
350 TPI V8
14.10 seconds @ 96.96 mph |
 
|  |
