Transmissions and DrivetrainNeed help with your trans? Problems with your axle?
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
My th350 tranny will not come out of low gear, has anyone ever had this problem before?? I pulled the pan, and the small "S" clip had came off and the linkage slipped out of place, so i fixed that and put the pan back on and it still does this... anyone know what the h#$@ is goin on here????
You need a vacuum signal to make the tranny shift. It connects to the vacuum modulator on the passenger side to the tranny.
__________________ LT1 headed LG4 305 beast! Comp Solid lifter XS-262-10S, 1.6 Roller Rockers, 10.2:1, Holley 4160 600cfm, modded Weiand 7502 intake to fit LT1 heads____ Custom cylinder head cooling. Weiand 8208 Short Water Pump____TH-350 3 series 3.73 with 2 series posi and spacer____ Hedman Hedders 1 5/8 headers and Y-pipe 3in Exhaust, Dynomax 3" Bullet muffler ____Moroso Ultra 40 Wires ACCEL HEI Super Coil ____Competition Engineering 3120 Bolt-on SFC's____Homemade: Wonderbar, solid tie rod sleeves, Aluminum LCA and Panhard Rod with spherical rod ends, alternator and PS bracket, Strut tower brace, and Decoupling torque arm with telescoping link.
3000lbs
"The liberty of a democracy is not safe if the people tolerate the growth of private power to a point where it becomes stronger than their democratic State itself. That, in its essence, is Fascism - ownership of government by an individual, by a group or by any controlling private power."
-FDR
"If this were a dictatorship, it'd be a heck of a lot easier, just so long as I'm the dictator."
-- President George W. Bush
During a photo-op with Congressional leaders on 12/18/2000.
yeah i checked both ends... they were both connected, and there was vaccum on the line... someone else suggested that i drop the valve body and check for a stuck valve....thanks
