(1)i see that there is 4 sensor on the trans. 3 on the driver side and 1 on the passager side. wat sensor r wat? second (2) wat does this black tube that runs along the top of the trans? is that just a air vent or a fill thing?? (3)last question does the lt1 starter mount just like the t5 starter??? thanks, any info will help for a faster and better swap.

i have an lt1 and a t-56 im putting in. the starter on the lt1 is mounted on the engine, and doesnt (as far as i can tell) interfear with the transmission at all. the tube on the top i believe is for the dipstick. one of the sensors is a speed sensor. u may need to look at a wiring diamgram for a 4th gen

ok.....a t-56 does not have a dipstick!
the tube is just a vent.
the starter mounts just like any other sbc starter does....to the block.
the sensor on the passenger side is the back-up light switch.
the one at the top center is the skip-shift solenoid which wouldn't be used if put into a 3rd gen unless doing a LT1 swap also.
the one at the shifter mount is your reverse lock-out.
the small one near the back is you vss.

there is an article i believe it is in the FAQ forum that has all this info and then some. really good article.

hahahahaha ok man! my bad! thats wat i was told...but my mistake.