Transmissions and DrivetrainNeed help with your trans? Problems with your axle?
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
My question would be since I have a th350 going in my '92 RS that has 3.73 rear, 25.65 inch tires and using a 2 pulse vss, would I use the 700r4 gear configuration such as 15 tooth drive gear and 44 tooth driven gear, same reluctor ring and all? Kinda lost here
Last edited by montecarlossman; 09-23-2009 at 03:01 PM.
Some TH350 tailhousings do accept the larger carrier that goes with 700R-4 speedo gears, so start with that. A regular 15 tooth drive gear in the shaft itself is all that's needed inside the tailhousing. On the outside, you'll need one of the driven gear carriers that accepts the 44 tooth, but has a wiring connector instead of a cable connector. You may already have one, but if not, they do exist.
Some TH350 tailhousings do accept the larger carrier that goes with 700R-4 speedo gears, so start with that. A regular 15 tooth drive gear in the shaft itself is all that's needed inside the tailhousing. On the outside, you'll need one of the driven gear carriers that accepts the 44 tooth, but has a wiring connector instead of a cable connector. You may already have one, but if not, they do exist.
Awesome! I've never had a 700r4 tailhousing off to actually see how it was assemble and how things fit, since this car came with a th350. Will most replacement speed sensors accept the 44 tooth gear?
