| small t5 leak from bolt on driver side of trans. Hi,
I was replacing the speed sensor on the t5 in my formula when I noticed a very small leak from the bolt near the top of the transmission case on the driver side. It looks like a torx bolt. I don't know what it holds. Should I try to tighten it and see if that does anything, or do I have to remove it and replace a seal inside? The leak is very slight, just enough to make the edges of the bolt wet with trans fluid, but not enough to cause drip down the transmission case. Any suggestions would be greatly appreciated. | | |
__________________ 91 Formula WS6 305TPI
Transmission: WC T5
diff: limited slip 3.42:1
exhaust:dual cat with 3" magnaflow cat back
mods: fully rebuilt 305 bored .020 over and decked 0.020, comp cams xr258hr12, 22lbs bosch design 3 injectors, full wide band tune, eibach lowering springs - 1.5" drop, spring tech shocks and struts, slotted brake rotors, underdrive pulleys, MSD ignition, K&N air filter with air foil. |